4.6 in fox mustang

[boss289]

i have a 95 thunderbird 4.6 i want to put in my 89 mustang.what parts could use from the tbird to make it work

[fastoleman]

i have a 95 thunderbird 4.6 i want to put in my 89 mustang.what parts could use from the tbird to make it work
I dont know if the k-member is the same..if its not you will need a 96-04 mustang k-member with fox lower C/A's and a set of C/A bushing from globalwest ($200). If you are going to do 5 lug on it then replace the ball joint in the C/A with a 96-04 one. That way you dont have the shim the spindle. If you are going to stay EFI...I think it would be better to get the WHOLE harness (front to rear) from a 96-98 mustang. It is tricky getting the harness in. You will have to cut a few extra holes in the inner fenders for the harness. I used a 96 mustang as my donor so i cant say for sure if the harness is even close to a T-Bird. You can use the whole exhaust system for a 96-98 under your fox.Dont know if the fuel tank is the same but is it is use it. Dont think the fuel lines would be the same.Does your trans have a cable for the speed-O?What dash are you gonna use fox or SN95?Hope this helps ya some.Good luck! I have a post under the projects here of my build if you need to see some of my mods i had to do.

[speedysmurf]

somebody knows their stuff....

[cammincoupe]

somebody knows their stuff....

sombody has done this swap befor lol.. :thumbsup1: