Adjusting new rear control arms

[fastbluestang]

I recently installed a complete UPR adjustable rear control arm set up on my car now the rear seems to sit too far to the right hand side of the car putting tire closer to quater panel on that side:headscratch: any help to fix this is much appreciated

[Silver91Hatch]

How did you adjust them out of the box???

[Silver91Hatch]

Also uppers, lowers or both??

[Long_Stroke]

The only way side to side is controled in the Fox 4 link setup is with the upper control arms. Check the length to make sure they are both the same.

This is assuming the upper torque boxes are okay.

[Notch93]

^^^^^ X2 Listen to Scott, he knows what he is talking about.:yes1:

[87notchback]

i got the same problem also. I measured my arms same as stock length ones. But im wondering when i changed my bushing in the rearend housing, to the urethane ones my "cups" slid a little. Im pretty sure this might be throwing my arms off some. What you guys think? Im thinking of installing UPR spherical bushings.

[Stable]

Make sure that you check the upper mounts very close...they can pull away from the body and cause that also

[Notthead]

:yeahthat:

[87notchback]

Make sure that you check the upper mounts very close...they can pull away from the body and cause that also


There good i just installed battle boxes

[Runningpony98]

had a problem with adjustables my first go round but like everything else it gets easier with time