PDA

View Full Version : 1980 - 1982 Ford Mustang Speedometer Cable Lower Section for Models with Cruise Contr


1ATony
09-07-2010, 03:05 PM
http://www2.1aauto.com/_include/gui/logo_large.gif
http://www.1aauto.com/img/ucart/images/partimage/1ATSC00002/main.JPG

CLICK ON LINK BELOW FOR CURRENT PRICING
1980 - 1982 Ford Mustang Speedometer Cable Lower Section for Models with Cruise Control (http://www.1aauto.com/1A/SpeedometerCable/Ford/Mustang/1ATSC00002/388516?utm_source=southeasternfoxbodies&utm_medium=forum&utm_campaign=1atony)

This speedometer cable is a new, aftermarket replacement part. It is just what you need to repair or replace a bent, broken, rusted or defective cable and get your speedometer working properly again.

Over time, many cables are susceptable to moisture and dirt penetrating through the outer casing and causing the inner transmission wire to rust or seize. This in turn may cause the wire to either snap or wear a hole in the outer casing. Also, after many years of use, the lubricant inside the casing will diminish allowing more friction to build up between the wire and casing causing failure.

If you do have a speedometer that is not working properly and the speedometer cable is the cause, this is the part for you!.

This speedometer cable has the following specifications:

Length:
63 Inches
Speedometer connection end:
Connection Type:
Screw on type
Round Nut
5/8-18
Metal Length:
1.600 Inches
Transmission connection end:
Screw on type
Round Nut
7/8-18
Built to strict quality control standards
Comes with a limited lifetime warranty against manufacturers defects

PURCHASE THIS PRODUCT HERE (http://www.1aauto.com/1A/SpeedometerCable/Ford/Mustang/1ATSC00002/388516?utm_source=southeasternfoxbodies&utm_medium=forum&utm_campaign=1atony)