Crazyhorse347
10-25-2008, 09:36 AM
Hello,
I am a new memeber from central Georgia, I have a 1987 Mustang GT, it has a brand new 347 Eagle Stroker in it with the following.
Eagle Crank and Rods
JE pistons
Seve Petty Custom Cam
AFR heads
Elderbrock Intake upper and lower
70mm BBK throttle body
BBK long tube headers
3 1/2 inch x pipe
Flex light dual fans
Msd billet Dist
Msd BTM and coil
89 Mass air conversion with SCT custom chip(NO O2's)
Performance Automatic C4 super comp trans Lifetime warrenty(1000+ hp)
tci convertor
Trans break
Ford motor sports drive shaft
UPR front tublar suspension
UPR rear contol arms
8,8 with 3.73 and a auburn pro unit
Moser 30 spline axels
c-clip emlinators
Moser rear cover
Florida 5.0 dash
autometer boost, tans temp, and fuel pressure
91 Gt seats
Dynoed at 502 horse power on a mild street strip tune on Pump Gas
Plus a few little things like a roll cage and quarter stick shifter...car still being built and has ran 10:66@125.17 so far on Radials with a 1.72 60 ft.
Crossbreed invited me to this site, Glad to be here!! Below is my car, click on the link.
http://i302.photobucket.com/albums/nn95/crazyhorse406/th_Picture063.jpg (http://s302.photobucket.com/albums/nn95/crazyhorse406/?action=view¤t=Picture063.flv)
I am a new memeber from central Georgia, I have a 1987 Mustang GT, it has a brand new 347 Eagle Stroker in it with the following.
Eagle Crank and Rods
JE pistons
Seve Petty Custom Cam
AFR heads
Elderbrock Intake upper and lower
70mm BBK throttle body
BBK long tube headers
3 1/2 inch x pipe
Flex light dual fans
Msd billet Dist
Msd BTM and coil
89 Mass air conversion with SCT custom chip(NO O2's)
Performance Automatic C4 super comp trans Lifetime warrenty(1000+ hp)
tci convertor
Trans break
Ford motor sports drive shaft
UPR front tublar suspension
UPR rear contol arms
8,8 with 3.73 and a auburn pro unit
Moser 30 spline axels
c-clip emlinators
Moser rear cover
Florida 5.0 dash
autometer boost, tans temp, and fuel pressure
91 Gt seats
Dynoed at 502 horse power on a mild street strip tune on Pump Gas
Plus a few little things like a roll cage and quarter stick shifter...car still being built and has ran 10:66@125.17 so far on Radials with a 1.72 60 ft.
Crossbreed invited me to this site, Glad to be here!! Below is my car, click on the link.
http://i302.photobucket.com/albums/nn95/crazyhorse406/th_Picture063.jpg (http://s302.photobucket.com/albums/nn95/crazyhorse406/?action=view¤t=Picture063.flv)