- flywheel?
- Lentech AOD Strip Terminator or equivelent.
- 10 factory axles any good?
- Streetable DD gear?
- Is it geared???
- scored some proform rockers
- oil coming out of 2 of the crankshaft holes ???
- crank & rods cast or steel ???
- short or long block ???
- 302 or 306 engine combos
- lsc brake caliper flip
- what head for 408 ???
- Stroker kit or not?
- 4 cyl to v8
- T5
- BBK headers
- Camshaft specs,Ford Racing,Comp Cams,TFS,Lunati and more!
- pic of shifters with a c4
- FINALLY !!!!!!!
- a head question
- History of the Borg Warner T-5 Transmission
- PCV blowout?
- Control arm bushings
- Auto-to-Manual Swap?
- t5 rebuild help
- Strocker / Head combo question
- Ford Racing wires...after 2.5-3 years use with a turbo setup
- Pulilng a T-5
- 306
- Buddys car dies and wont start sometimes?
- Bellhousing
- Lets see those shifters
- hydroboost setup
- Type F Tranny Fluid in the power steering pump to quiet pump......
- gt40x
- help with catch can......
- AOD RPM question
- AOD Question
- can anyone help me out???
- Anybody have a RAM HDX clutch?
- need some advice???
- What clutch
- Installing cam
- Name that intake....
- MSD PRo Billet distributor HELP!
- Can I get rid of stock prop. valve on a fox disk brake conversion?
- MSD Pro Billet Dizzy or MSD Street Fire?
- Mounting the A1000
- intake question(89 fuel injected)
- Need Help on a 3550 Tremec
- 4R/AODE in a fox
- help
- My Flywheel? Stock?
- how to on vavle adjustment.
- ARP harmonic Balancer bolt to torque tight?
- My 302 motor
- F303 frpp cam 1.6 or 1.7 roller rockers?
- heads
- Where to get rear-end gear installed
- replacing clutch..
- procomp heads
- Throttle body whistle?
- Lets talk about broken Pinion Shaft retaining bolts
- 351W, need a list
- Pushrod Lenght
- Crankshaft seal replacement
- shifter handles for short arms
- phenolic spacer
- good start to winter mods
- 351 roller conversion?
- choosing a cam
- NEW INTAKE
- Transmission Codes? Help
- Rear Disc Brakes
- T/B sticking
- Hy-guard fluid in built auto?
- best place to buy 351W swap headers
- 93 5.0 Shift RPM Question
- New Shifter Handle
- what heads with a victor EFI 5.0?
- a few 5spd questionss
- aod transmission guru...........
- how stiff will the pedal be?
- Which camshaft to buy??
- What radiator for my car?
- T5 Transmission Problem.
- What serie are the head motors?
- fuel sending unit
- pilot bearing questions
- Need cam help.
- Need bolt size and thread configuration...
- Painted Intakes are on! Whatcha think?
- 5spd help
- what adjust to be at on bbk fuel pressure?
- upr firewall adjusters
- 84 GT ???
- New oil pan advice?
- Anyone have done?
- what size is this Holly??????
- Got a start on the oil pan today!!
- New Toys for WHITE POWER !!!!!!!
- YOU GUY WITH AUTO TRANS ???
- Old School Holley Valve Covers
- Adjustable cable quadrant??
- Where to get custom speedo cable? Charlotte area?
- anybody rebuild t5s
- AOD epoxy mod...
- Had to post this here - 8.8 Traction Locks
- upr firewall adjuster
- tranny upgrade question
- Loud ticking noise...Need help!
- Tremec info needed
- Hard Shifting
- help pick cam
- One Centerforce Clutch well done , to go.
- What air cleaner are you running??????
- HCI question
- help please!!!
- noisy bearing??
- Best fuel regulator for stock fuel rails.
- Anyone need a spec clutch?
- Battery light?
- 2500 stall converter ???
- Strange tranny thing?
- witch engine would you get
- which heads
- 393 performance issues
- Bearing and rings to use with nitrous (150-200 shot)
- 347 setup but unsure of cam combo
- continous CEL timing and idle issues. please read
- no fluid in converter??
- IS A 3000 stall to much 4 this cam ???
- HELP! engine noise!
- what U GUYS THINK OF THESE heads ?
- Running Rough!
- Belt size
- aod to 5speed